|
Infinite Menus, Copyright 2006, OpenCube Inc. All Rights Reserved.
|
 No-Mar Film |
 |
 |
|
Excellent protection against die marks & scratches. |
|
Useful for stainless steel, aluminum or pre-painted metal. |
|
Help protect your dies. |
|
Quick setup, universal, save time & money |
|
Available in .015 & .030 "Thk x 100" L |
|
Widths: 4".6", "12", "36" |
 |
Excellent protection against die marks & scratches. |
|
|
|
Useful for stainless steel, aluminum or pre-painted metal. |
|
Help protect your dies. |
|
Quick setup, universal, save time & money |
|
Available in .015 & .030 "Thk x 100" L |
|
Widths: 4".6", "12", "36" |
|
Positioning Device clamps on to the die rail, and can stretch the film and position it anywhere on the width of the die. |
|
Can use 4" wide Brake Die films of 0.015"-0.030" thick. |
|
Film can be positioned anywhere on the width of the die (1-V or 2-V die.) |
|
Film Height is adjustable from 60mm (2.362") to 120mm(4.724") from the base. |
|
 |
|
| Available in 2 types for easy installation: |
Model DFPE: for EUROPEAN STYLE Machines- with 60mm wide base
Model DFPA: for AMERICAN STYLE Machines - with a 1/2" x 5/8" Tang |
| No-Mar Film |
|
No-Mar Film |
|
No-Mar Film |
No-Mar Film is tough urethane film, for using between a press brake die and the part being formed.
|
|
No-mar Film can be used with existing steel dies. |
|
No-mar Film will prevent marking in press brake forming operations for stainless steel, aluminium or pre-painted metals. |
| |
|
|
|
|
| No-Mar Film |
|
No-Mar Film |
|
No-Mar Film |
| No-Mar Film is lightweight, safe and economical to use. |
|
No-Mar Film will eliminate post grinding and polishing costs. |
|
No-Mar Film will produce clean, smooth bends. |
| |
|
|
|
|
| No-Mar Film |
|
|
|
|
| No-Mar Film will reduce wear on your dies. |
|
|
|
|
| |
| Instructions |
No-Mar Film is very easy to use, yet offers excellent protection from die marks and scratches. To maximize film life, we suggest that you try the following set-up procedure on your press brake.
- Set your punch and die for bending the metal piece to the desired angle before placing the film over the die.
- Raise the ram setting approximately .015" to allow space in the die for the No-Mar Film to flow. Very Important.
- Cover the lower die with the film. You may wwant to tape one edge of the film to the lower die using the duct, or two-face tape. This will help hold the film in place during a production run. However, the other edge must be free to remove.
- Begining forming. Film life depends on the number of factors such as the type of material being formed, thickness of the metal being formed, type of angle being formed , etc. Watch film for signs of deterioration, and replace when worn.
|
| |
|
|
|
|
